AMETEK CW-P User Manual
Cw-p series programmable ac power source, Operation manual
Table of contents
Document Outline
- M161691-01_contents Rev K.pdf
- SECTION 0 INTRODUCTION
- SECTION 1 SPECIFICATIONS
- SECTION 2 INSTALLATION
- SECTION 3 OPERATION
- SECTION 4 PROGRAMMING
- 4.1 Programming the CW Via the Front Panel
- 4.2 Measurement Operations
- 4.3 Menu Operations
- 4.3.1 Self Test
- 4.3.2 Set GPIB Port
- 4.3.3 Specify Current Limit Type
- 4.3.4 Specify Shutdown Delay
- 4.3.5 Specify Program Keys Locked Mode
- 4.3.6 Store Present Machine Settings
- 4.3.7 Recall Machine Settings
- 4.3.8 Specify Relay State After Power Up Initialization
- 4.3.9 Clock Direction
- 4.3.10 Analog Input State
- 4.3.11 RMS Voltage Loop
- 4.3.12 Phase A Offset
- 4.3.13 Phase B Offset
- 4.3.14 Phase C Offset
- 4.3.15 Slave Channel
- 4.3.16 Slave Address
- 4.3.17 Slave Configuration
- SECTION 5 MAINTENANCE