AMETEK CW-P - Manual (Page 44)

Installation Elgar CW-P Series
2-22 Operation Manual
26. Rotate the right knob until the right display reads “A”.
27. Press the ENTER/SAVE button.
28. Set up the B phase.
29. On the B master CW press the “ENTER/SAVE” button.
30. Rotate the left knob until the left display reads “Addr”.
31. Rotate the right knob until the right display reads “0”.
32. Press the ENTER/SAVE button.
33. Press the ENTER/SAVE button.
34. Rotate the left knob until the left display reads “ChAn”.
35. Rotate the right knob until the right display reads “B”.
36. Press the ENTER/SAVE button.
37. On the B slave CW press the ENTER/SAVE button.
38. Rotate the left knob until the left display reads “Addr”.
39. Rotate the right knob until the right display reads “1”.
40. Press the ENTER/SAVE button.
41. Press the ENTER/SAVE button.
42. Rotate the left knob until the left display reads “ChAn”.
43. Rotate the right knob until the right display reads “B”.
44. Press the ENTER/SAVE button.
45. Set up the C phase.
46. On the C master CW press the “ENTER/SAVE” button.
47. Rotate the left knob until the left display reads “Addr”.
48. Rotate the right knob until the right display reads “0”.
49. Press the ENTER/SAVE button.
50. Press the ENTER/SAVE button.
51. Rotate the left knob until the left display reads “ChAn”.
52. Rotate the right knob until the right display reads “C”.
53. Press the ENTER/SAVE button.