AMETEK CW-P - Manual (Page 10)

Contents Elgar CW-P Series
vi Operation Manual
3.8 Remote Control Signal ........................................................................ 2-15
3.8.1 Analog Amplitude Control ........................................................ 2-15
3.8.2 Lock to External Frequency Source ........................................ 2-15
3.8.3 Sync Output Pulse ................................................................... 2-16
3.9 Master/Slave Configurations ............................................................... 2-16
3.9.1 Setup for Single–Phase, Two Units ......................................... 2-17
3.9.2 Setup for Three–Phase, Two Units per Phase ........................ 2-20
SECTION 4 OPERATION .................................................................. 3-1
4.1 CW Front Panel Controls and Indicators .............................................. 3-1
4.2 Front Panel Overview ............................................................................ 3-4
4.3 Power Up .............................................................................................. 3-5
4.4 Programmed Frequency Steps ............................................................. 4-6
SECTION 5 PROGRAMMING ............................................................ 4-1
5.1 Programming the CW Via the Front Panel ............................................ 4-1
5.1.1 VOLTAGE/POWER Section ...................................................... 4-2
5.1.2 CURRENT/FREQUENCY Section ............................................. 4-2
5.2 Measurement Operations ..................................................................... 4-2
5.2.1 Supply Measurements on the Left Display ................................ 4-2
5.2.2 Supply Measurements on the Right Display .............................. 4-3
5.3 Menu Operations .................................................................................. 4-4
5.3.1 Self Test .................................................................................... 4-5
5.3.2 Set GPIB Port ............................................................................ 4-5
5.3.3 Specify Current Limit Type ........................................................ 4-6
5.3.4 Specify Shutdown Delay ............................................................ 4-6
5.3.5 Specify Program Keys Locked Mode ........................................ 4-6
5.3.6 Store Present Machine Settings ................................................ 4-6
5.3.7 Recall Machine Settings ............................................................ 4-7
5.3.8 Specify Relay State After Power Up Initialization ...................... 4-7
5.3.9 Clock Direction .......................................................................... 4-7
5.3.10 Analog Input State .................................................................... 4-7