AGI Security SYS-16HN44P - Manual (Page 277)

265
Parameter Function
message screen if you enabled this function.
Buzzer Check the box here to enable this function. The buzzer beeps
when an alarm occurs.
Alarm upload System can upload the alarm signal to the centre (Including alarm
centre.
Message When 3G network connection is OK, system can send out a
message when motion detect occurs.
Send Email If you enabled this function, System can send out an email to alert
you when an alarm occurs.
Tour You need to click setup button to select tour channel. System
begins 1-wiindow or multiple-window tour display among the
channel(s) you set to record when an alarm occurs. See Figure
5-58.
PTZ
Activation Here you can set PTZ movement when alarm occurs. Such as go
to preset X. See Figure 5-57.
Snapshot Click setup button to select snapshot channel. See Figure 5-59.
Video Matrix This function is for motion detect only. Check the box here to
enable video matrix function. Right now system supports
one-
channel tour function. System takes “first come and first
serve” principle to deal with the activated tour. System will process
the new tour when a new alarm occurs after previous alarm ended.
Otherwise it restores the previous output status before the alarm
activation.
5.8.3.1.2 Video Loss
The video loss interface is shown as in Figure 5-60.
Please note video loss does not support anti-dither, sensitivity, region setup. For rest setups, please refer
to chapter 5.8.3.1.1 motion detect for detailed information.