AGI Security SYS-16HN44P - Manual (Page 140)

128
position, please right click channel 1 video window and then drag to the channel 16 video window,
release button, you can change channel 1 and channel 16 position.
 Tour setup: Here you can set preview window channel display mode and interval. Please follow the
steps listed below.
From Main menu->Setting->System->Display->Tour, you can see an interface shown as in Figure 4-35.
Here you can set tour parameter.
 Enable tour: Check the box here to enable tour function.The general tour supports all types of
window split mode.
 Interval: Input proper interval value here. The value ranges from 1-120 seconds.
 Motion tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Video detect->Motion detect to enable tour function.
 Alarm tour type: System support 1/8-window tour. Please note you need to go to the main
menu->Setting->Event->Alarm to enable tour function.
 Window split:It is to set window split mode.
Figure 4-35
Tips
On the navigation bar, click / to enable/disable tour.
Click Save button to save current setup.
4.7 PTZ
Note:
Before you control the PTZ, please make sure the PTZ decoder and the NVR network
connection is OK and the corresponding settings are right.
4.7.1 PTZ Settings
Cable Connection