D-Link DI-1162M - Manual (Page 96)

DI-1162/DI-1162M Remote Access Router
90
WAN 1
Items in the screen are described as follows:
♦
Tx Packets – The total number of valid packets transmitted by the router since the last reset.
♦
Tx Bytes – The total number of bytes transmitted by the router.
♦
Tx Discard Packets – The number of packets dropped by the router.
♦
Tx Error Packets – the number of invalid packets transmitted by the router. This hardware counter shows the
sum of Collisions, Abort, and Underrun packets.
♦
Tx Underrun Packets – Runt packets. This counter shows the number of packets transmitted by the router that
are less than the allowed 64-octet minimum length. Underrun packets occur due to jam signals generated by
collisions, backpressure, etc.
♦
Tx Lost CTS Packets – The number of Clear To Send packets that were lost by the router.
♦
Rx Packets – The total number of packets received by the router.
♦
Rx Bytes – The total number of bytes contained in packets received by the router.
♦
Rx Unknown Packets – The number of packets received by the router that were of an unsupported protocol.
♦
Rx Discard Packets – The number of packets dropped by the router.
♦
Rx Error Packets - Number of invalid packets received by the router. This hardware counter shows the sum of
NOA, Abort, CRC, Overrun, CD Lost, Framing, and Parity error packets.
♦
Rx NOA Packets – Non-Octet Alignment. This counts the number of packets received by the router that did
not end on a byte boundary. The receipt of a misaligned packet will generate a single NOA event regardless of
the number of misaligned octets in the packet.
♦
Rx Abort Packet – The number of packets that were dropped due to user generated breaks in the transmission
that occurred while a packet is being received.
♦
Rx CRC Packets – The number of packets received that failed the CRC checksum test.