D-Link DI-1162M - Manual (Page 12)

DI-1162/DI-1162M Remote Access Router
6
LED STATUS/ FUNCTION
Power Lights whenever the router is plugged in, turned on, and thus
receiving power.
Diag Lights during the startup Power-On Self-Test (POST) test.
Boot Lights briefly during startup after the PROM program has
executed. Indicates a successful boot up.
Run Should be slowly blinking if the router is functioning properly.
10/100 This LED is ON for a 100Mbps link, and OFF for a 10Mbps
link.
LAN
Link/Act This LED is ON to show a good link to the LAN, and quickly
flashes to show communication activity on the line.
Full/Half This LED is ON for a full-duplex connection, and OFF for
half-duplex.
Col The LED flashes to show transmission collisions on the line.
WANs
1 & 2
Ready This LED is ON to show a good modem or CSU/DSU link to
the WAN port.
Act This LED flashes to show communication activity on the line.
Module
Ready This LED is ON to show a good modem or CSU/DSU link to
the WAN module, or a good link to the LAN port module.
Act This LED flashes to show communication activity on the line.
♦
Diagnostics RS-232 Serial Port A DB-9 female connector used to connect a console to the router for initial
setup and out-of-band management.
♦
Wan Ports (1 and 2) Two DB-25 male connectors each of which can be connected to a dial-up (dial in or out)
line or a dedicated leased line by multiplexing with a modem or CSU/DSU (Channel Service Unit/ Data
Service Unit), respectively.
♦
Slot for Add-in Module This slot is able to house any one of the following slide-in expansion modules:
◊
A single RJ-45 10/100 Ethernet port
◊
Two high-speed serial (async/sync) ports
◊
A BRI ISDN module (S/T interface only).
♦
LAN Port This jack is a full featured RJ-45 10/100 Ethernet/Fast Ethernet port. This feature allows this port
to automatically configure itself to match the settings used by the port it is being connected to. If it is connected