D-Link DI-1162M - Manual (Page 61)

DI-1162/DI-1162M Remote Access Router
55
Commands
Script files can perform six Commands. You can choose the appropriate command by positioning the cursor in the
Command field and pressing to toggle to the desired command. The script commands are defined as
follows:
♦
Wait – This command waits for text defined in the Parameter field to be transmitted by the ISP. In the above
example, the router will wait for the ISP to prompt for ‘ Username: ’. Please note that the parameters are
case-sensitive and must be an exact match.
♦
Transmit – Transmits the exact characters written in the Parameter field. There are also three keywords that
can be transmitted:
◊
^I – Username, as defined in the Remote Network Profile submenu.
◊
^P – Password, as defined in the Remote Network Profile submenu.
◊
^M – or .
♦
Delay – Will delay for the number of seconds defined in the Parameter field.
♦
Get My IP – Will get the IP address from the ISP if the ISP sends it. This command is only valid for SLIP
connections.
♦
Get Srv IP – Will get the Servers IP address if it is sent. This command is only valid for SLIP connections.
♦
End – Ends the script file.
Parameters
Parameters are data fields which hold text or numbers that are used in the Wait, Transmit, and Delay
commands.
State
Toggles to enable or disable the line item.