D-Link DI-1162M - Manual (Page 37)

DI-1162/DI-1162M Remote Access Router
31
♦
Stub Area – Toggle between Yes and No. AS external advertisements are not flooded into/throughout stub
areas. Routing to AS external destinations in these areas is based on (per area) default only.
♦
Stub Default Cost (0. . 255) – Enter a Stub Default Cost between 0 and 255 in this field.
♦
State – This enables or disables a particular entry.
♦
Address Ranges – Enter the Range Net, Range Mask, Advertisement status, and Enable the State of up to five
OSPF entries in these fields. This allows users to manually enter OSPF subnet information. Range Net and
Range Mask describe the collection of IP addresses contained in the range. Networks and hosts are assigned to
an area depending on whether their addresses fall into one of the area’s defining address ranges.
Advertisement is set to either Yes or No. Routing information of these address ranges is advertised external to
the area if and only if such status is set to Yes.
OSPF Intf. Configuration
Select the desired interface on the OSPF Intf. Configuration screen:
Complete the OSPF interface configuration information on the screen below: