Setting the switches, Figure 2-12. com mode selection switches – Adept AnyFeeder User Manual

Page 29

Installing Cables and Power

Adept AnyFeeder User’s Guide, Rev. B

Setting the Switches

The Adept AnyFeeder will be set for serial communications. The Com Mode Selection
switches (see

) must be set as follows:

1. Move the A switch (selects Parallel I/O or RS232) to the down position, to select

Serial.

Figure 2-12. Com Mode Selection Switches

After changing the switch settings, you must cycle power to the Adept AnyFeeder.

• If the Adept AnyFeeder and connected equipment are powered from a common

source, you can turn that source off and then back on.

• If the Adept AnyFeeder and connected equipment are powered from different

sources, then you must disconnect and then reconnect the following cables:

• 24 VDC power cable. See

for

details

• Digital I/O interface cable. See

for details