Zilog EZ80F91AZA - Manual (Page 18)

The eZ80AcclaimPlus! Development Kit UM024402-0812
8
eZ80AcclaimPlus! Development Kit
User Manual
Connecting the eZ80AcclaimPlus! Development Board to
your PC
Observe the following procedure to connect the eZ80AcclaimPlus! Board to your PC.
Disconnect or turn off the power to the eZ80AcclaimPlus! Development Board before
connecting or disconnecting the USB Smart Cable.
1. Connect one end of the 6-circuit ribbon cable provided in your Kit to the USB Smart
Cable unit, ensuring that the ribbon’s male connector is aligned correctly with the
female connector on the unit, as indicated by the red stripe in Figure 3.
2. Connect the other end of the ribbon cable to Debug Connector J1 on the Development
Board. Ensure that Pin 1 on the ribbon cable is aligned with Pin 1 on the target con-
nector, as highlighted in Figure 4.
Figure 3. Connecting the Six-Conductor Ribbon Cable to the Serial or USB Smart Cable
Caution: