Zilog EZ80F91AZA - Manual (Page 14)

The eZ80AcclaimPlus! Development Kit UM024402-0812
4
eZ80AcclaimPlus! Development Kit
User Manual
1. Insert the ZDS II disc into the CD-ROM drive. The DemoShield installation applica-
tion should launch automatically. If DemoShield does not launch automatically, open
Windows Explorer, browse to your CD-ROM drive, and double-click the
launch.exe executable file to launch the DemoShield installer.
2. In the DemoShield main menu, click the Install Products button. From the list of
products to install, you can choose to install only ZDS II or to install both ZDS II and
all associated documentation. As an option, you can also copy the documentation
directly from your CD-ROM drive to your hard disk.
The eZ80AcclaimPlus! Development Board is shipped with all settings at their defaults;
these settings are listed in
Table 2 on page 16. It is important to determine that the settings
on your Board are correct before you continue with installing and running the demo.
Installing the USB Smart Cable Driver
The USB Smart Cable can be installed on PCs that run on Windows 7 (32- and 64-bit),
Windows Vista (32- and 64-bit) and Windows XP operating systems. The procedures in
this section will guide you through the USB Smart Cable installation process.
Windows 7 32/64 Systems
Observe the following steps to install the USB Smart Cable on a Windows 7 system.
1. Connect the USB Smart Cable to a USB port on your development PC. When the PC
detects the new hardware, it will display the Installing device driver software dialog.
2. Windows automatically searches for the driver; this process can take a few moments.
Because there is no option to terminate this search process, wait for the search to complete.
If the driver was previously installed, Windows will automatically install the USB
Smart Cable driver. If this is the case, skip ahead to
Step 9 . If Windows cannot find the
driver, close the search dialog and proceed to the next step.
3. From the Start menu, navigate via the Search Programs and files menu, and enter
Device Manager in the Search field to cause the Device Manager to appear in a list of
search results.
4. From this search list, click Device Manager to open the Device Manager dialog,
which presents a list of devices that operate on your PC. Find Other devices , toggle it
to view a sublist of additional devices, and right-click your mouse on USB Smart
Cable .
5. In the submenu that appears, click Update Driver Software... .
Note: