Zilog Z8F1621 - Manual (Page 6)

In-Circuit Emulator
User Manual
UM016804-0208
3
installing the package adapter that came with your kit into the compatible
socket on a target board such as the Z8 Encore! XP
®
F64xx Series Devel-
opment Board; connecting the emulator to a PC; and connecting the emu-
lator to the target.
You may have to reconfigure network settings on the PC or on the Z8
Encore! XP
®
F64xx Series ICE before using the emulator.
1. Install the Z8 Encore! XP
®
F64xx Series MCU package adapter into
the socket on your target board, being sure to line up the guide pins
with the guide pin holes on the socket.
2. Connect the CAT-5 crossover cable from the PC to the Ethernet port
on the Z8 Encore! XP
®
F64xx Series ICE. See Figure 1 .
If you prefer, you can connect the emulator to an Ethernet hub
using a standard CAT-5 patch cable.
3. Connect the serial COM port on the PC to the serial port on the Z8
Encore! XP
®
F64xx Series ICE using the DB9-to-DB9 serial cable.
See Figure 2 .
Figure 1. Connecting a PC to the Z8 Encore! XP
®
F64xx Series ICE
Note:
PC Z8 Encore! XP
F64xx Series
ICE
CAT-5 Crossover Cable
DB9-to-DB9 Cable