Zilog Z8F1621 - Manual (Page 15)

In-Circuit Emulator
User Manual
UM016804-0208
12
Changing Z8 Encore! XP
®
F64xx Series ICE Settings to Match
the PC
1. Connect the PC serial port to the Z8 Encore! XP
®
F64xx Series ICE
serial port using the DB9-to-DB9 serial cable.
2. Launch HyperTerminal on the PC by selecting Start --> Programs -->
Accessories --> Communications --> HyperTerminal.
3. In the Connect To dialog, set the Connect Using: drop-down menu to
match the COM port to which the Z8 Encore! XP
®
F64xx Series ICE
is connected. Click OK.
4. A COM Properties dialog appears. Enter the following port settings
and click OK.
Bits per second:
57600
Data bits: 8
Parity: None
Stop bits: 2
Flow control: None
5. HyperTerminal should automatically attempt a connection. If not,
select Call --> Connect.
6. While holding down the z key (lowercase) on the PC’s keyboard,
press the RESET button on the back panel of the Z8 Encore! XP
®
F64xx Series ICE. Releasing the z key displays a Z8 Encore! XP
®
F64xx Series ICE console boot-up message in HyperTerminal, fol-
lowed by the > prompt. A typical boot-up message is shown below.
1540096 bytes physical mem
RAM Block0 from 100000 to 17ffff
Flash/ ROM from 8000 to fffff
172701 bytes Code
15947 bytes Data
321128 bytes user stack/heap space
Starting at 131991