Zilog S3F8S19 - Manual (Page 6)

UM026801-0914 Supported Host Environments
S3F8S19 Development Kit
User Manual
3
Supported Host Environments
The S3F8S19 Development Board supports the following operating systems:
• Microsoft Windows 7 (32-bit/64-bit)
• Microsoft Windows Vista (32-bit/64-bit)
• Microsoft Windows XP
Install the ZDS II Software and Documentation
Observe the following steps to download and install your ZDS II software and documenta-
tion.
If you have already installed ZDS II – S3 and have downloaded the software
and documentation by following the procedure on the paper insert in your kit (FL0167),
skip ahead to the next section.
1. Prior to connecting the S3F8S19 Development Board to your development PC, down-
load ZDS II for S3 Family devices version 5.2.0 (or later) from the Downloadable
Software category in the Zilog Store.
2. When the download is complete, unzip the file to your hard drive. Double-click the
installation file named ZDS II – S3_.exe, and follow the on-screen instruc-
tions.
Establish a Connection with the PC
Observe the following procedure to connect the S3 Flash ISP and S3F8S19 Development
Board to your PC.
Disconnect or turn off the power to the S3F8S19 Development Board before connecting
or disconnecting the S3 Flash ISP.
1. Connect the Mini-B side of the USB A (male)-to-Mini-B cable to the S3 Flash ISP.
Connect the other end of this cable to the PC, as shown in Figure 2.
Note:
Caution: