Zilog S3F8S19 - Manual (Page 36)

UM026801-0914 Run the S3F8S19 Boot Loader Demo
S3F8S19 Development Kit
User Manual
33
Appendix E. Run the S3F8S19 Boot Loader Demo
Observe the following procedure the run the S3F8S19 Boot Loader Demo sample project.
1. Set the Tera Term program to 57600-8-N-1. Alternatively, you can use other terminal
programs such as HyperTerminal or RealTerm.
If you use Tera Term, the recommended version is 4.83.
2. Launch ZDS II by navigating from the Windows Start menu to Programs → Zilog
ZDS II–S3 → ZDS II–S3 .
3. From the File menu in ZDS II, select Open Project , and navigate to the following
filepath:
\samples\S3F8S19\BL_Demo
4. Select the S3F8S19_BL_Demo.zdsproj project from within the BL_Demo folder and
click Open . A list of source files will appear in the Workspace panel.
5. Select Build → Rebuild All .
6. Select Debug → Download Code to initially program the S3 device with the boot
loader library and application program.
7. Select Debug
→
Stop Debugging .
8. Remove the S3 Flash ISP’s 10 pin ribbon cable from the S3F8S19 Development
Board's J6. Upon removing the ribbon cable, the Tera Term screen displays the mes-
sage shown in Figure 36.
9. On the terminal program, press and hold the letter z on your keyboard, then press
SW1/ RESET once on the S3F8S19 Development Board.
Figure 36. Starting Application Message Display
Note: