Zilog S3F8S19 - Manual (Page 30)

UM026801-0914 Run the S3F8S19 Monitor Demo
S3F8S19 Development Kit
User Manual
27
Appendix D. Run the S3F8S19 Monitor Demo
Observe the following procedure to run the S3F8S19 Monitor Demo sample project.
1. If you are using Tera Term as your console program, set it to 57600-8-N-1.
Alternatively, you can use another program such as HyperTerminal or RealTerm.
If you use Tera Term, the recommended version is 4.83.
2. Set the appropriate COM port by looking at the Device Manager and checking the
COM port that the USB Serial Port is assigned to. In this example, the USB Serial Port
is assigned to COM5, as indicated in Figure 29.
3. Launch ZDS II by navigating from the Windows Start menu to Programs → Zilog
ZDS II–S3 → ZDS II–S3 .
4. From the File menu in ZDS II, select Open Project , and navigate to the following
filepath:
\samples\S3F8S19\Mon_Demo
5. Select the S3F8S19_Mon_Demo.zdsproj project from within the Mon_Demo
folder, as shown in Figure 30, and click Open . A list of source files will appear in the
Workspace panel.
Figure 29. Set the COMx
Note: