Zilog S3F8S19 - Manual (Page 12)

UM026801-0914 Start the S3F8S19 Ledblink Sample Program
S3F8S19 Development Kit
User Manual
9
8. After selecting S3FlashIsp from the Debug Tool drop-down menu, click Setup to
select the serial number of the S3 Flash ISP you are using, as indicated in Figure 10.
The serial number you see on your screen will be different from the serial number shown
in Figure 10.
9. Click OK to close the Setup USB Communication dialog box.
10. Click OK to close the Project Settings dialog box.
11. If you are prompted to rebuild any affected files, click Yes . Otherwise, choose Build
from the menu bar, then click Rebuild All . The following message is displayed.
OUTPUT CHECKSUM
ledblink.hex C3A7
ledblink.lod C3A7
0 warning(s)
0 error(s)
Build succeeded.
This Output Checksum message is an example and may not match the actual checksum of
the project for a particular release of the ZDS installation software.
Figure 10. The Setup USB Communication Dialog
Note:
Note: