Vectronics VEC-1292K - Manual (Page 20)

VEC-1292K Owner’s Manual Stereo Transmitter Kit
20
ENCLOSURE
To install your transmitter in the VEC-1292KC matching enclosure follow these
instructions (read all instructions before beginning ... take your time):
1. Find the front panel decal and rear panel decal; separate using scissors. Be sure to
leave excess decal material around the edges. Put the front panel decal on first.
This is done by: a.) Remove all debris and oil from the chassis. b.) Remove the
crack and peel to expose the adhesive. c.) Place the decal on the front panel without
securing it completely. d.) Gently rub the alignment circles with your finger--if the
circles are centered in the enclosure holes (also check the corner alignment marks)
secure the decal by rubbing and removing all air bubbles. e.) If the alignment circles
are not centered, adjust the decal accordingly then secure. f.) Use a penknife, or
small Exacto
TM knife, to cut away the unused edges and cut out the component holes
(cut from the description side). g.) Repeat this procedure for the rear panel using
the corner alignment marks.
2. Next, install the two L-brackets on the chassis using two of the 3/16" screws. The
longer side of the L-bracket must be connected to the chassis using the two holes
centered on each edge of the enclosure. Refer to the diagram on the next page for
location and orientation.
3. Install the three 1/2" mounting screws next. Insert the screws, from the bottom,
through the three holes in the chassis.
4. Place the three 3/16" round spacers on the mounting screws.
5. Now insert the PC board. This must be done by: a.) Insert the front of the PC board
at an angle so the controls enter their respective holes. b.) Push down on the rear of
the board. Make sure the mounting screws align with the mounting holes in the PC
board before pushing.
6. Use the three hex nuts to secure the PC board. Be certain all appropriate
components are centered with the enclosure holes before tightening.
7. Find the switch cap. Align the switch cap with SW1 and push it on. If it is difficult
to push on, then rotate it 90° and try again.
8. Locate the piece of double-sided tape. This is to be used for holding the 9-volt
battery clip in place. Locate a place on the underside of the top cover where the
battery will not interfere with any components. Peel off the backing of the tape and
stick it to the chosen location.
9. The top should be installed next. Use the two remaining 3/16" screws for securing
the top to the L-brackets. Make sure the L-brackets are aligned properly.
10. Place the small round bushing into the hole on the top of the box. Press the bushing
down until it snaps in. Then slide the antenna through the hole and screw onto the
ANT screw until tight.
11. Finally, place the four rubber feet on the bottom of the enclosure at the corners.