Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual

Page 8

P/N: 4809640

03APR06 v1.0 01Cobra(4809640v1.0)

Unplug the EGR sensor, located at the rear

most portion of the upper plenum . (See

Fig. 1-e.)

Lift the upper plenum up, and disconnect the

two small vacuum hoses located at the rear of

the plenum . Lay the plenum onto the driver’s

side of the engine compartment . (See

Fig. 1-h .)

Relieve the pressure in the fuel rail by

depressing the small Schraeder Valve with a

phillips head screwdriver . A small amount of

fuel will come out of the valve, so have a

clean rag ready . Remove the 10mm bolts (2

per side) that secure the fuel rails to the intake

manifold . (See Fig. 1-i .)

Using a 1-1/16" open end wrench, loosen the

EGR tube, located at the rear of the EGR

valve . (See Fig. 1-f .)

Fig. 1-e

Fig. 1-h

Fig. 1-i

Fig. 1-f

Fig. 1-g

Remove the eight 8mm upper plenum bolts .

(See Fig. 1-g .)

Lift the rails up and remove the stock injectors

from the intake manifold . The injectors are

sealed with O-rings and may be difficult to

remove, but they will come out . Replace them

with the supplied High Performance Injectors .

(See Fig. 1-j.)