Air intake system modifications – Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual

Page 23

P/N: 4809640

03APR06 v1.0 01Cobra(4809640v1.0)

Fig. 6-a

Fig. 6-b

Fig. 6-c

Fig. 6-d

These steps illustrate how to install the new intake sys-

tem .

Disassemble to supplied air intake as shown,

leaving the hose clamp indicated loose so the

elbow can be rotated once the assembly is

mounted in the car . (See Fig. 6-a .)

lEAVE lOOSE

Remove the two nuts located in the passenger

side inner fender wall . Push the mass air

meter/air filter assembly and inlet tube up into

the passenger side fender, and attach to the

existing studs in the inner fender panel using

the two factory nuts . (See Fig. 6-b .)

Assemble the inlet tract as shown, with the

rubber elbow clamped to the plastic inlet tube

and the bypass valve assembly in place .

Route the long PCV tube from the underside

of the plastic inlet tube to the PCV fitting on

the passenger side valve cover . Tuck the free

end of the bypass valve assembly underneath

the cast aluminum discharge tube . Insert the

plastic intake tube into the flex hose, and the

rubber elbow onto the supercharger inlet . (See

Fig. 6-d .)

Attach the length of flex hose to the plastic

elbow on the MAF/air filter assembly inside

the fender (See Fig. 6-c .) Install the cast-alu-

minum discharge tube using the supplied rub-

ber joints and stainless steel clamps .

Once you have determined that the inlet tube

assembly is positioned properly, tighten all

clamps .

Section 6

AIR INTAKE SYSTEM MODIFICATIONS

AIR INTAKE SYSTEM

MODIFICATIONS