Preparing to install the supercharger – Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual

Page 15

P/N: 4809640

03APR06 v1.0 01Cobra(4809640v1.0)

PREPARING TO INSTALL THE

SUPERCHARGER

The air conditioner system fill port (located

near the upper radiator hose) must be bent

from its current, vertical position to a horizon-

tal position parallel to the top of the radiator .

(See Fig. 3-a.) This must be done to clear the

bottom portion of the supercharger .

*** NOTE ***

use extreme caution during this step. The refriger-

ant contained in the line is under high pressure

and can cause injury if the line ruptures. use an

approved tube bender, if available, or use heavy

gloves and bend by hand. In either case, wear

safety goggles/glasses to protect your eyes in case

of a line rupture.

Using the supplied bolts, attach the idler sup-

port bracket to the remaining empty holes

from Step 23 . The idler support bracket serves

as a support for the main supercharger bracket

and mounting point for the supplied idler pul-

ley . (See Fig. 3-b.)

Fig. 3-a

Fig. 3-b

Fig. 3-c

Remove the 18mm stud bolt that is located

under the lower corner of the passenger side

valve cover . This stud bolt supports the wiring

loom through the use of a small tab . Save the

tab for later step . (See Fig. 3-c.)

Section 3

PREPARING TO INSTAll THE SuPERCHARGER