Paxton Superchargers Mustang Cobra, NOVI 1000 System User Manual

Page 16

P/N: 4809640

03APR06 v1.0 01Cobra(4809640v1.0)

Fig. 3-e

Fig. 3-f

Fig. 3-g

Fig. 3-h

Remove bolt from factory idler pulley and

discard . (See Fig. 3-e.)

Mount the supplied idler pulley, snap-ring

side facing out, on the idler support bracket

using the supplied hardware . Trial fit the idler

pulley first; if it does not fit, one of the ribs

on the alternator must be ground off . (See

Fig. 3-f.)

When the pulley clears the alternator it can be

bolted into place . Install the stock idler pulley

in its original location, followed by the water

pump pulley using the factory hardware . (See

Fig. 3-g.)

Install the supplied accessory/supercharger

drive belt and route as stock, but do not install

on alternator pulley until after the supercharg-

er is installed . Instead, leave a loop in the belt .

(See Fig. 3-h.)

Install the rear S/C mounting bracket as

shown . (See Fig. 3-h.) Be sure to install the

idler pulley spacer, wiring loom tab, and spac-

er . (Refer to Appendix ‘C’ for more detail)