NEXCOM NEX 732L2G - Manual (Page 54)

53 Chapter 4 NEX732L2G User Manual
4.15 Load Optimized Defaults
Figure 4-12: BIOS – Load Optimized Defaults
This option opens a dialog box that lets you install optimized defaults for all appropriate items in the whole
setup utility. Press the <Y> key and then <Enter> to install the defaults. Press the <N> key and then
<Enter> to not install the defaults. The optimized defaults place demands on the system that may be
greater than the performance level of the components, such as the CPU and the memory. You can cause
fatal errors or instability if you install the optimized defaults when your hardware does not support them. If
you only want to install setup defaults for a specific option, select and display that option, and then press
the <F7> key.
4.16 Set Supervisor/User Password
The Supervisor/User Password utility sets the password. The main board is shipped with the password
disabled. If you want to change the password, you must first enter the current password, then at the prompt
enter your new password. The password is case sensitive. You can use up to eight alphanumeric characters.
Press <Enter> after entering the password. At the next prompt, confirm the new password by retyping it and
pressing <Enter> again.
To disable the password dialog box appears. A message appears confirming that the password has been
disabled. If you have set supervisor and user Password, only the supervisor password allows you to enter
the BIOS setup program.