NEXCOM NEX 732L2G - Manual (Page 47)

46 Chapter 4 NEX732L2G User Manual
Onboard LAN (1 & 2) Boot ROM
Decide whether to invoke the boot ROM of the onboard LAN chip. The available choices are LAN1, LAN2,
and Disabled.
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC) installed on the system board and you
wish to use it. If you install an add-in FDC or the system has no floppy drive, select Disabled in this field.
Onboard Serial Ports (1, 2)
Select an address and corresponding interrupt for the first and second serial ports.
The choices: Auto, 3F8/IRQ4, 3E8/IRQ4, 2F8/IRQ3, 2E8/IRQ3, Disabled.
UART Mode Select
This item allows you to select UART mode. The choices: Normal, IrDA, ASKIR.
RXD, TXD Active
Choices for RXD, TXD Active include Hi, Hi; Hi, Lo; Lo, Hi; and Lo, Lo.
IR Transmission Delay
Select Enabled for IR transmission delay.
UR2 Duplex Mode
In an infrared port mode, this field appears. Full-duplex mode permits simultaneous two-direction transmission.
Half-duplex mode permits transmission in one direction only at a time. Select the value required by the IR
device connected to the IR port.
Use IR Pins
There are two choices -- RXD2, TXD2 and IR-RX2TX2 -- available for use of the IR Pins.
Onboard Serial Ports (3, 4)
This feature allows you to manually select the I/O address and IRQ for the first and second serial ports. It is
recommended that you leave it as Auto so that the BIOS can select the best settings for it. But if you need
a particular I/O port or IRQ that's been taken up by this serial port, you can manually select an alternative I/
O port or IRQ for it. You can also disable this serial port if you do not need to use it. Doing so frees up the
I/O port and IRQ used by this serial port. Those resources can then be reallocated for other devices to use.
Onboard Parallel Port
This feature allows you to manually select the I/O address and IRQ for the onboard parallel port. The default
I/O address of 378h and IRQ of 7 should work well in most cases. Unless you have a problem with the
parallel port, you should leave it at the default settings. The choices: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, and
Disabled.