CRU Drive eRazer Ultra - Manual (Page 5)

PMS 711 2 cyan 85 magenta 76 yellow 10.25.12
CRU Mark
Page 5
• At the next screen, press ENTER to continue. The
settings are now reset to the factory defaults.
3.3 View Drive Info
This screen displays information about the attached drive.
• From the “Home/Start Erasing” screen, press the UP or
DOWN buttons to get to the “View Drive Info” screen.
Press ENTER.
• Use the UP or DOWN buttons to scroll through and view
the following info about the drive.
Appearance on LCD Explanation
Capacity (Bytes) Capacity of the HDD, measured
in bytes.
Manufacturer Manufacturing company name
of the HDD.
Model number Model number of the HDD.
Serial number Serial number of the HDD.
Firmware Rev Firmware revision number of the
HDD .
HPA size (Bytes) The size of the Host Protected
Area of the HDD, measured in
bytes.
DCO size (Bytes) The size of the Device Configura-
tion Overlay of the HDD, mea-
sured in bytes.
Disk health Displays the S.M.A.R.T. health
status of the drive.
Secure Erase Nor time Time reported by the drive that
it will take to use Secure Erase
(Normal).
Secure Erase Enh time Time reported by the drive that
it will take to use Secure Erase
(Enhanced).
Start/Stops S.M.A.R.T. information on how
many times the drive has spun
up and spun down.
Power cycles S.M.A.R.T. information on how
many power on/off cycles the
drive has underwent.
Bad sectors Number of bad sectors reported
by the drive.
PRINTER OUTPUT
>
SMALL LABEL 4x1
CHANGE SETTING? >
3.2.4 Label Printer Output
Drive eRazer Ultra features a DB9 null-modem serial
connection for the purpose of connecting a label printer.
This will allow Drive eRazer to print a label recording
details of an erase process. This occurs at the end of the
process. The label can then be affixed to the drive, or
to a DriveBox™ anti-static storage case. There are two
output modes, one for a 4” x 1” label and one for a 4” x
6” label. You may also print a label as a test without an
erasure process.
• From the “Review Settings” screen, press ENTER
and then UP or DOWN to get to the “Printer
Output” screen. Press ENTER.
• The current Printer Output setting will display, along
with an option to change the setting. Press ENTER to
change, or UP or DOWN to print a test label.
• Use the UP and DOWN buttons to scroll through the
printer options: Small Label 4x1 or Large Label 4x6.
Press ENTER to select.
• After you select the printer option, you will be
prompted to make your selection the default. Pressing
ENTER saves the mode as the default. Pressing UP or
DOWN sets and continues without saving as default.
3.2.5 Reset to Factory
From this screen, you can reset the settings on Drive
eRazer Ultra to the factory defaults.
Function Factory Default Setting
Erase Mode Quick Erase
HPA/DCO Handling Ignore All
Validation Minimal
Label Printer Output Small Label 4x1
• From the “Review Settings” screen, press ENTER and
then UP or DOWN to get to the ”Reset to
Factory” screen. Press ENTER.
PRINT TEST LABEL
>
CHANGE LABEL TO
LARGE LABEL 4x6
>
LARGE LABEL 4x6
MAKE DEFAULT?
>
RESET TO FACTORY
>
CONTINUE >
VIEW DRIVE INFO
>