Dimension One Spas Aquatic Fitness System - Manual (Page 28)

Dimension One Spas - Aquatic Fitness System - Owner’s Manual
26
Troubleshooting Guide
Heating System
Symptom Problem Corrective Action
1. Temperature setting is too low 1. Turn up the thermostat
2. Dirty filter 2. Clean filter
Does not heat
3. Flow switch out of adjustment 3. Call for service
1. Temperature setting is to high 1. Turn down the thermostat Too hot
2. High limit tripped 2. Call for service
Flashing temperature of 34
°F or
134 °F appears on the display
Possible temperature sensor failure Call for service
Electrical System
Symptom Problem Corrective Action
Will not turn on – in any mode No power Check circuit breaker and/or GFCI
Turns on by itself Normal automatic daily power filtration,
or anti-freeze cycle No action required
Light will not turn on Burned out bulb Replace bulb
1. Automatic timer has shut pump off 1. Push JETS button to start another
cycle. If desired reprogram
automatic pump timer for a longer
duration.
Pump shuts down unexpectedly while
in use
2. Motor over-heated and automatic
protective device has shut down
pump(s)
2. If pump(s) will not restart when
JETS pad is pushed, call for
service
1. Check water level
2. Clean filter
If problem persists:
1. Turn off power
2. Restart the system
If problem persists:
3 flashing lights appear on the Control
Panel Possible sensor errors
Call for service
Water System
Symptom Problem Corrective Action
Pulsating jets Water level too low Fill with water to approximately 6 inches
below the top edge of the pool/spa
1. HydroTherapy Jets closed 1. Open Jets
2. Diverter Valve turned 2. Turn the Diverter Valve clockwise
or counter clockwise
3. Dirty Filter 3. Clean Filter
4. Air lock 4. Loosen pump union to allow air to
escape
No Jet Action, or action is poor
5. Gate valve closed 5. Open gate valve
1. Check TA/pH
2. Test and adjust
The water is cloudy or has a smell The water has a chemical imbalance or
lack of filtration.
3. Change Water if necessary