Dimension One Spas Aquatic Fitness System - Manual (Page 16)

Dimension One Spas - Aquatic Fitness System - Owner’s Manual
14
Messages that Appear in the Display Window
Overheat
DO NOT ENTER THE WATER when “OH” is displayed on the
control system’s Digital Display Window because the spa is in a high
temperature condition. If this happens, remove the spa cover and
allow the water to cool below 110
° F (≅43.3° C). Turn off all power to
the system to reset.
If the problem persists, contact your local Authorized Dimension One
Spas Dealer, or authorized service center.
The overheat condition could be caused by excessive
filtration. See the Troubleshooting Guide section for
more information (pg. 26).
3 Flashing Lights
DO NOT ENTER THE WATER if you see 3 flashing LEDs on the Top
Side Control. The system has detected a problem.
Check to see of your Digital Display Window is also displaying an
Overheat Protection condition (OH). If you have flashing lights and
an OH in the display, your system has detected a high limit condition.
The water temperature has reached 118
° F (≅47.8° C). The entire
system is disabled.
Contact your local Authorized Dimension One Spas Dealer, or
authorized service center.
If you have flashing lights, but the Digital Display Window shows the
current water temperature, you have a water flow problem. You will
need to check the water level and/or clean the filters.
The flashing lights should stop once the problem is fixed. If the
problem persists, reset the power to the spa by resetting the GFCI
breaker.
If the error is not resolved after resetting the spa, contact your local
Authorized Dimension One Spas Dealer, or authorized service
center.
Extreme Temperature on
the Display
Do not enter the water if you see a temperature reading of 32° F
(
≅0° C) or 136° F(≅57.8° C) without first checking the actual water
temperature with a certified thermometer. The system has detected a
Temperature Probe Failure and the water may be too hot, or too
cold, to safely use.
Contact your local Authorized Dimension One Spas Dealer, or
authorized service center.
Ice
When ICE appears in the Display Window, the air temperature has
dropped below a factory-preset level, and the system has activated
“Smart Winter Mode.” The pump will automatically run to circulate
the water and prevent it from freezing.
This is a normal function and no action is necessary.