CIRCUTOR AR5L Series - Manual (Page 49)

49
10.- MAINTENANCE
The analyzer does not require any special maintenance. No adjustment,
maintenance or repairing actions should be done over the instrument open and,
should those are essential, high-qualified operators must perform them. Spares
should be provided by manufacturer.
The batteries are rechargeable and should be provided by manufacturer
Before any adjustment, replacement, maintenance or repairing operation is
carried out, the instrument must be disconnected from any power supply source.
When any protection failure is suspected to exist, the instrument must be
immediately put out of service.
The own instrument design permits a quick replacement in case of damage.
NOTE: Occasionally clean the equipment with water and detergent using a
soft, damp cloth. Do not use abrasives or solvents. Completely dry the
equipment before using it again.
11.- CHANGING THE BATTERY
It is possible to change the battery with a simple an easy way. The battery is
placed in rear part of the analyzer.
Before opening the cover to disconnect all the connections of tension
and current
In order to change the battery, do the following steps.
1. Remove the cover
2. Unplug the battery
3. Replace the battery (the
single connector enters
a position, not to force)
4. Place the cover
If you wants to request a battery for replace the code it is M89904.