Casella CEL Microdust 880 IS real time dust monitor - Manual (Page 36)

Microdust 880nm & WinDust Application Software
Handbook HB3255-03
Page 36 of 51
Advanced WinDust features
Modem Communications
A remotely located Microdust may be interrogated via a modem telephone link. Clicking the
telephone button shown above will open the following configuration screen:-
Initialise:-atz0^M^J~~
These commands are used to initialise the modem. Atz0 resets the modem. '^M' generates a
carriage return. '^J' generates a line feed. Each '~' symbol creates a pause of one second.
Dial :- atdt320^M^J
The dialling command and stations telephone number should be placed within the dial line.
Connect:- CONNECT
This is used to define the message generated by the modem following a successful connection.
HangUp:- ~+++~ath0^M^J
This line defines the escape sequence used to select command mode and hang up the telephone
line
O.K:- O.K
This represents the message generated by the modem following successful command execution
Connect Time:- 60
If the time required to successfully connect to the remote station exceeds the set value then the
communications session will be terminated.
Idle Time:- 60