Casella CEL Microdust 880 IS real time dust monitor - Manual (Page 25)

Microdust 880nm & WinDust Application Software
Handbook HB3255-03
Page 25 of 51
Transferring profiles
The configuration information contained within a profile must be transferred across to the Microdust.
Before attempting to transfer a profile make sure that;-
•
The Microdust is switched on.
•
The serial communications cable is plugged into both the Microdust and the appropriate
serial port on your computer.
To transfer a profile, select Logger

Send setup... from the menu or click on the
icon.
Click on the ‘Send’ button to start the transfer. Any errors encountered will be reported and the
transfer procedure aborted.
During the transfer, the Microdust’s internal clock will be programmed using date and time values
from the P.C. Ensure the P.Cs clock is correctly set!
Recording data with the Microdust Logger
All logger related options on the Microdust are grouped within a ‘Logger’ sub menu. Pressing the
‘Enter’ key will enter the logger menu.
Before recording data, it is necessary to check several parameters which determine the loggers
current operating mode.
•
Logging interval.
The ‘logging interval’ represents the time between each recorded data point. The interval may be
adjusted from 2 to 600 seconds.