Casella CEL CEL-310 - Manual (Page 9)

2. PREPARATION
It is recommended that the instructions and information contained in this
handbook be read before operating the equipment.
2.1 Unpack the Equipment
Carefully remove all components of the Dose Badge system from the
shipping container or carrying case and inspect them for possible damage
or missing items. If there appears to be damage or something missing,
please contact Casella CEL or your local representative immediately. The
following components should be included.
CEL-310 Dose Badge,
CEL-315 Dose Reader Unit,
C6801/2 RS232 Cable (2 m),
-PC18 Mains Power Supply (with UK, EU or USA plug
as ordered,
CEL-6802 Mounting Kit for Dose Badge consisting of
Blank Mounting Plate,
Mounting Plate with Safety Pin Attachment,
Leather Mounting Patch,
Windshield,
Safety Pins (x2).
CEL-6803 Hard Hat Mounting Kit,
CEL-6804 dBLink Dose Badge Software on a CD,
CEL-6805 dBDatabase Software (ordered separately),
CEL-6806 Carrying Case for Dose Badge System with
up to 10 Badges,
060349/HB Operating Manual.
At least one of the following items will also be supplied as ordered
CEL-6807/2 Charger for 2 Dose Badges,
CEL-6807/5 Charger for 5 Dose Badges,
CEL-6807/10 Charger for 10 Dose Badges.
Please check that any other components that were ordered have been
included with the equipment.
2.2 Quick Start
This is the recommended procedure for performing personal sound
exposure measurements using a single Dose Badge and Reader.
1. Charge the Dose Badge battery (Section 2.3).
Preparation
CEL-310 Dose Badge Users Handbook - Page 9