Applied Motion Si5580 - Manual (Page 4)

-4-
Getting Started
To use your Si5580 motor control, you will need the following:
a power cable (line cord) •
a compatible step motor •
a small flat blade screwdriver for tightening the connectors - an Applied Motion Products screw- •
driver suitable for this purpose is included with your drive.
a personal computer running Windows 3.2, 95, 98, NT, W2K, XP, Vista or Vista64, with a 9 pin •
serial port (486 or better with 8 MB RAM recommended)
the Si Programmer • TM software that came with your Si5580
the programming cable and adapter that came with your Si5580 •
Si Programmer • TM software manual
The sketch below shows where to find the important connection and adjustment points. Please
examine it now.
All mating connectors are included.
Si5580
Step Motor Driver
POWER
TEMP
SHORT
B–
B+
A–
A+
MOTOR
N
G
L
AC
POWER
PC/MMI
LIMITS
STOP
IN 1
IN 2
IN 3
IN 4
JOG CW
JOG CCW
IN/JOG COM
IN/JOG COM
CW+
CW-
CCW+
CCW-
OUT 1+
OUT 1-
OUT 2+
OUT 2-
OUT 3+
OUT 3-
FAULT+
FAULT-
90V pk
I/O Connector
inputs 1-4
jog cw, ccw
I/O Connector
cw, ccw limits
I/O Connector
outputs 1-3
fault output
LEDs
power
overtemp
overcurrent
RS232 connector
pc
mmi
AC power connector
Motor connector
STOP button
Always use the blue & white
Applied Motion screwdriver
with the above I/O connectors.
Larger screwdrivers may remove
the plastic dimples that prevent
the screws from falling out.