Applied Motion Si5580 - Manual (Page 19)

-19-
Flush Mounting
When you remove the MMI from the shipping carton, you will notice that it has two parts. The first
is a fairly thin section that contains the keypad, display and some circuit boards. The other part is
thicker and contains the telephone jack and a cable that connects to the keypad assembly.
When you flush mount the MMI in a panel, only
the thin section will stick out from your panel - the
large portion mounts behind your panel. You’ll
need to cut a precise section from your panel.
There is a cardboard template in the MMI’s ship-
ping box for this purpose.
If you want the MMI to be dust proof and watertight,
you must place the black rubber gasket between the
thin part of the MMI and your panel. Assemble the
two halves using the eight small screws provided.
Surface Mounting
An easier way to mount the MMI is to bolt the two halves together ahead of time, using the eight small
screws. If you want the MMI to be dust proof and watertight, put the black rubber gasket between the
two halves before screwing them together.
Then cut a hole in your panel for the cable that runs
between the MMI and the Si5580. The hole must
be at least 5/8” in diameter for the connector to
fit thorugh. You will also need two holes that line
up with the big mounting holes in the MMI. The
mechanical outline on page 21 shows the location
of the big mounting holes.
1
2
3
4
5
6
7
8
9
YES
NO
.
0
SPACE
BKSP
ENTER
panel
MMI
(front section
and gasket)
MMI
(rear section)
1
2
3
4
5
6
7
8
9
YES
NO
.
0
SPACE
BKSP
ENTER
panel
sealant (not included)
MMI
gasket
(included)