Directed Electronics Ready Remote - Manual (Page 25)

21 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
wire color according to the web information. With your black
test probe lead still in the kick panel, probe the suspected wire
with the red lead of your test probe. With the brake pedal at rest
the LED tester should be extinguished. While watching the test
probe, depress the brake pedal. The LED tester should illumi-
nate Red. Once you have located the correct brake wire, solder
the small BROWN (H1/3) wire of the main harness to it and
wrap the connection with electrical tape.
Installing the hood pin switch requires drilling a ¼-inch hole in the
metal lip under the hood. Choose a location that will allow the pin
switch to be depressed when the hood is closed. The pin switch has
a spade connector on the bottom for the wire connection.
warning! Do not use the vehicle until you
confirm the operation of the brake shut-
down.