Directed Electronics Ready Remote - Manual (Page 21)

17 © 2 0 0 6 D i r e c t e d E l e c t r o n i c s
step 3
Accessory and Starter wires
The starter and accessory wires will be located in the same harness
as the ignition and constant power.
To find the accessory wire leave the LED tester black lead
connected to the metal ground, take the red lead and probe the
wire suspected to be the accessory. With the key off, your test
probe’s LED should be off. Turn the key to the on position and
the LED tester should be illuminated Red. Now turn the key to
the crank position. If you have the correct accessory wire the LED
will extinguish while the starter is cranking and return once the
key returns to the on position. If the wire tests correctly, strip the
➜
87
87A 86 85
30
+12 VDC CONSTANT (FUSED 20A)
GROUND
PINK/WHITE (+) OUTPUT
TO 2nd IGNITION
TO 2nd IGNITION
TO 3rd IGNITION
3rd IGNITION RELAY
(NOT PROVIDED)
87
87A 86 85
30
+12 VDC CONSTANT (FUSED 20A)
GROUND
TO 2nd IGNITION
2nd IGNITION RELAY
(NOT PROVIDED)