Equalizer control 1 – Dolby Laboratories KDC-W8534 User Manual
Page 15
English
|
15
Equalizer Control
1
Select the source to adjust
Press the [SRC] button.
2
Select the key function section
Press the [NEXT] button.
Repeatedly press the button until "EQ" is
displayed above the [3] button.
Refer to
(page 9).
3
Enter Equalizer Control mode
Press the [3] ("EQ") button.
• When "2 ZONE" of
you cannot select "EQ".
4
Select the Equalizer Control item to adjust
Press a [1] — [3]/[5] button.
Multi-function key operation
Equalizer Control Item
[1] "SYS.Q"
System Q Setting
[2] "F"
Equalizer Front Setting
[3] "R"
Equalizer Rear Setting
[5] "Preset"
[1] "RCL"
[2] "MEM"
Recall mode
Memory mode
• "Preset": You can store an adjusted equalizer control
value by selecting "MEM". Refer to
selecting "RCL". Refer to
5
Adjust the Equalizer control item
System Q Setting (Sound Type)
Push the Control knob towards [
4] or
[
¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound setting
Display
User memory
"USER"
Natural
"NATURAL"
Rock
"ROCK"
Pops
"POPS"
Easy
"EASY"
Top 40
"TOP 40"
Jazz
"JAZZ"
• User memory:
The values set on the
• Change each setting value with the Management system> (page 14). Equalizer Front Setting/ Equalizer Rear Setting Press the [2] ("F") or [3] ("R") button. 2 Select the items to adjust for Equalizer. Push the Control knob towards [FM] or [AM]. 3 Adjust the Equalizer. Push the Control knob towards [ 4] or [ ¢]. Each time you push the knob, the setting Equarizer adjustment item Range Equalizer Front Frequency/ Refer to the followings. Equalizer Front Level/ –9 — +9 Equalizer Front Quality/ 0.25/ 0.50/ 1.00/ 2.00 • The frequency which can be selected by each Frequency band is shown below. Band Frequency Band1 60/ 80/ 100/ 120/ 160/ 200 Hz Band2 250/ 315/ 400/ 500/ 630/ 800/ 1k Hz Band3 1.25/ 1.6/ 2/ 2.5/ 3.15/ 4 kHz Band4 5/ 6.3/ 8/ 10/ 12.5/ 16 kHz • To get the best sound, first set the Cabin Setting and Speaker Select Front/Rear parameters using the 6 Exit Equalizer Control mode Press the [6] ("RTN") button.
First, select the speaker type with the Speaker setting.
1 Select a frequency band you wish to adjust.
Each time you press the button, the band
alternates between "Band 1" and "Band 4".
Each time you push the knob, the item to be
adjusted alternates between the items shown
in the table below.
alternates between the settings shown in the
table below.
Equalizer Rear Frequency
Equalizer Rear Level
Equalizer Rear Quality