Dolby Laboratories KDC-W8534 - Manual (Page 11)

English | 11
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time you press the button, the Attenuator
turns ON and OFF.
When the Attenuator is ON, "ATT" is displayed.
Audio Control
1 Select the source to adjust
Press the [SRC] button.
2 Enter Audio Control mode
Press the [VOL] knob.
3 Select the Audio item to adjust
Press the [VOL] knob.
Each time you press the knob, the item to be
adjusted alternates between the items shown in
the table below.
4 Adjust the Audio item
Turn the [VOL] knob.
Adjustment Item Display Range
Rear Volume * 1 "Rear Volume" 0 — 35
Subwoofer level* 2,3 "Sub-W Level" –15 — +15
Balance "Balance" Left 15 — Right 15
Fader* 3 "Fader" Rear 15 — Front 15
Exit Audio Control mode (Volume control mode)
• * 1 You can control this item when "2 ZONE" of
Setup> (page 12) is set to "ON".
• * 2 You can control this item when Speaker Select
Subwoofer of (page
14) is set to any item other than "None".
• * 3 You can control this item when
Output> (page 11) is set to "SW ON".
• * 3 You can control this item when "2 ZONE" of
Setup> (page 12) is set to "OFF".
5 Exit Audio Control mode
Press any button.
Press a button other than the [VOL] knob, [ANG]
and [ATT] button.
Subwoofer Output
Turning the Subwoofer output ON or OFF.
Push the Control knob toward [AM] for at
least 2 seconds.
Each time you press the button, Subwoofer
output switches ON and OFF.
When it is ON, "SW ON" is displayed.
• You can control this item when Speaker Select
Subwoofer of (page
14) is set to any item other than "None".
• You can control this function when "2 ZONE" of
(page 12) is set to "OFF".