Dolby Laboratories KDC-W8534 User Manual
Page 13
English
|
13
• "Preset": You can store an adjusted audio control
value by selecting "MEM". Refer to
selecting "RCL". Refer to
• X'Over (Crossover Network Setup)
You can manually set a crossover frequency for the
speakers.
• DTA (Digital Time Alignment)
Manually set the sound output timing of each
channel.
5
Adjust the Sound Field Control item
Push the Control knob towards [
4] or
[
¢].
Each time you push the knob, the setting
alternates between the settings shown in the
table below.
Sound Field Control Item
Range
Front High Pass Filter Center/
Rear High Pass Filter Center*
2
Through/30 — 100/120/150/
180/220/250 (Hz)
Front High Pass Filter Slope/
Rear High Pass Filter Slope*
2
/
Subwoofer Low Pass Filter Slope*
1
-12/-18/-24 dB/oct
Subwoofer Low Pass Filter Center*
1
30 — 100/120/150/180/220/
250 (Hz)/Through
Subwoofer Low Pass Filter Phase*
1
Reverse/ Normal
DTA Front/DTA Rear
*
2
DTA Subwoofer
*
1
0 — 610 (cm)
Position Setting
Front-L/ Front-R/ Front/ ALL
• When the "2 ZONE" of
"ON", the following setups are ignored.
- "XOver"
- "DTA"
- "POSI"
- "Preset"
• *
1
You can control this item when Output> (page 11) is set to "SW ON". • * 1 You can control this item when Speaker Select Subwoofer of • * 2 You can control this item when Speaker Select Rear of 6 Exit Sound Field Control mode Press the [6] ("RTN") button.
14) is set to any item other than "None".
any item other than "None".