Altera RTE for OpenCL - Manual (Page 46)

Figure 4-2: Key Components of the Cyclone V SoC Development Kit
1. Writing an SD Card Image onto the Micro SD Flash Card on Linux on page 4-17
To write an SD card image onto the micro SD flash card on Linux, extract the SD card image from the
Cyclone V SoC Development Kit Reference Platform, and then write the image onto the micro SD
flash card.
2. Configuring the SW3 Switches on page 4-18
Configure the SW3 dual in-line package (DIP) switches on the Cyclone V SoC Development Kit.
3. Setting Up Terminal Connection in Linux on page 4-19
To set up the terminal connection for the Cyclone V SoC Development Kit in Linux, specify the USB
virtual COM port settings.
4. Setting Environment Variables and Loading OpenCL Linux Kernel Driver on page 4-19
After you turn on the board and establish terminal connection, log into the Cyclone V SoC
Development Kit as user
root
with no password. Then, before you run your host application, set the
environment variables and load the OpenCL Linux kernel driver.
5. Connecting the Board to Network via Ethernet on page 4-20
Connecting the Cyclone V SoC Development Kit to the host network allows you to transfer files to and
from your SoC.
Writing an SD Card Image onto the Micro SD Flash Card on Linux
The Altera SDK for OpenCL (AOCL) includes a Cyclone V SoC Development Kit Reference Platform. To
write an SD card image onto the micro SD flash card on Linux, extract the SD card image from the
OCL005-15.0.0
2015.05.04
Writing an SD Card Image onto the Micro SD Flash Card on Linux 4-17
Getting Started with the Altera RTE for OpenCL for Altera ARMv7-A SoC Altera Corporation
Send Feedback