Woodhaven 4963: Taper Master - Manual (Page 2)

1
ASSEMBLY
Most people use their miter gauge in the left miter
slot so these directions show that location being used.
Open the 17-3/4" Jig Bars (4918B) and assemble/adjust
the bars according to the instructions that come with them.
Lay the Jig Bars (4918B) with their countersunk holes facing
down, end-to-end in the miter slot of your saw. Align the
mounting holes in the MDF Base (4963B) with the threaded
holes in the bars so that the MDF Base overhangs the cutting
path of the blade by 1/2" or less. Attach the bars to the MDF
Base with 1" screws (MF010 - in 4918B hardware pack) and
re-check the fit of the bar/base assembly, making sure it slides
smoothly.
Turn the saw on and cut off the edge of the MDF
Base overhanging the saw blade (This should be no
more than 1/2"!), guiding the bar/base assembly
in the miter slot. Turn the saw off, disconnect
the power and lower the blade completely.
INSTALL FENCE
Attach the Ultra Track Fence (4963A) to the MDF
Base. Install a washer (WS002) and a 1/8" spacer
(BUSH001) on the ratchet handles (5864).
Align the slots in the 32" Fence with the slots in the
Base. Insert the stud of the ratchet handle thru the slot of the
Fence and the Base. Place a square nut (NUT025) in the recess
in the underside of the Base and screw the handle into the nut.
MF010
x6
Trim no more
than 1/2” from base
1
2
Fence Knobs x3:
5864
WS002
BUSH001
NUT025
4963B
Base
4963A
Fence