Woodhaven 4963: Taper Master User Manual

Additional hardware

4963

Taper Master

Owners Manual

Please Read Carefully!

Part# Description Qty.
WS002 Washer

Part# Description Qty.
5760B Oval

Nut

Part# Description Qty.
HB030 1"

Bolt

Part# Description Qty.
BUSH001 1/8"

Spacer

Part# Description Qty.
BUSH002 1/4" Spacer

Part# Description Qty.
5590 Knob

Part# Description Qty.
BUSH004 5/8" Spacer

Additional Hardware:

Parts listed below are not shown in the hardware

drawings. Refer to photos in the instructions:

Part Description

Quantity

4963B MDF

Base

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1

4963A

32” Ultra Track Fence . . . . . . . . . . . . . . . . . . . . . 1

6305IC

Inboard Clamp . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

4918B

17-3/4" Jig Bars . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

Part# Description Qty.
NUT025 Square

Nut

Part# Description Qty.
5505 Thumb

Screw

Part# Description

Qty.

5864 Ratchet

Handle 3

BEFORE BEGINNING
The

4963 Taper Master makes cuts up to 40" long and

can be used in either miter slot of a table saw as long as the
miter slot is between 4" to 7-1/2" from the saw blade. Make
sure the 40" capacity is sufficient and your miter slot locations
are in the range given before proceeding. Identify and verify
that you have all the parts listed. Read the instructions at least
once, familiarizing yourself with the parts, before beginning
assembly. You’ll need a #2 Phillips screwdriver for assembly.

The Taper Master relies on the miter slot of your saw being

parallel to the saw blade for it to work properly. If this is not the
case, make those adjustments to your saw before proceeding.
The 4963 Taper Master may also be used on a band saw.