beautypg.com

Woodhaven 7280: Bandsaw Fence User Manual

Page 3

background image

2

3

4

ASSEMBLE GUIDES, ATTACH TO TRACKS

Install a washer (WB002 on each 3/4" bolt (HB020). Install a bolt

thru both the hole and the center slot of each Angle Bracket (7280C).
Loosely fasten an Angle Bracket to the smooth side of each Guide
(7280E) by screwing two bolts into the threaded holes in the Guide.
Install a washer (WB002) on both Ratchet Handles (5863, 1-1/8" stud),
insert the stud thru the remaining slot in the Angle Bracket and the hole
in each Guide, then start an oval nut (5760B - smooth side first) on the
end of each stud. See fig. 3.

The Angle Bracket will partially overhang the Guide and the over-

hang will face in towards the band saw table.

Position and slide the Guides on to the 24" Double Tracks. The

rib of the Guide and the oval nut will fit into the T-slot of the track.
Position the Guides on the tracks an equal distance from the end of each
track and tighten the Ratchet Handles. See fig. 3.

ATTACH ULTRA TRACK FENCE
& SQUARE VERTICALLY

Insert a 1-1/4" bolt (HB040) thru the center hole in the vertical

face of each Angle Bracket. Install a 1/2" spacer (BUSH5050) and a
knob (5540) on the end of each bolt. Slide the 24" Ultra Track (4424)
onto the heads of the bolts and tighten the knobs. See fig. 4.

If desired, the Ultra Track fence can be adjusted for square verti-

cally. Slightly loosen the two knobs holding the Ultra Track fence to
the Angle Brackets. Insert a thumb screw (5505) in the top or bottom
threaded hole in the vertical leg of each Angle Bracket. Use the top hole
to push the top of the fence away from the Angle Bracket. Use the bot-
tom hole to push the bottom of the fence away from the Angle Bracket.
Adjust the thumb knobs to square the fence, retighten the knobs and
recheck the fence for square. See fig. 4.

5863 &

WB002 x1

HB020 &
WB002 x2

5760

Knob - Spacer - Bolt

5505 - vertical square adjustment - forward tilt

5505 - vertical square adjustment - rear tilt

5540 - BUSH5050 - HB040

4424 24” Ultra Track
Slides over bolt heads

Guide Assembly Cross Section

7280C
Angle
Bracket

7280C Angle Bracket

4424 Ultra Track fence

7280E Guide

7280E Guide

Ratchet Handle
adjusts to clear

fence & hardware

Rib of Guide &
Oval Nut align
in slot in Double
Track. Slide
assembly on to
Double Track.