Waldorf Lector User Manual
Page 40
Appendix
Lector User´s Manual
40
3. Check the settings in the Output section. Only
“Vocoder” should be up, as shown in the screenshot.
4. Select Latch in the Trigger section.
5. Make sure that you have selected Synthesizer in the
Input section.
6. Start the playback of your host application.
7. Depending on your source signal, enhance the sibilent
frequencies to improve intelligibility by adjusting the UV
Detector. Make sure it’s on (indicated by the LED) and
adjust the values to your requirements.
Classic Vocoder controlled by MIDI notes
This is the typical setup for using the Vocoder musically,
i.e. creating a melodic Vocoder effect, typically using the
internal synthesizer.
1. Choose a track where you would like the audio to be
processed. Alternatively you can choose a virtual
instrument track (e.g. sample player).
2. Load Lector directly in one of the channel´s insert slots.
3. Check the settings in the Output section. Only
“Vocoder” should be up, as shown in the screenshot.
4. Select Normal or Single in the Trigger section,
depending on if you would like the Vocoder to be
monophonic or polyphonic.