Waldorf Lector - Manual (Page 36)

The Controls in Detail
Lector User´s Manual 36
Speed 0...20 Hz
Sets the LFO speed of the Chorus effect.
Depth 0...100%
Sets the modulation depth of the Chorus effect.
Feedback -100...100%
Feeds the Chorus output signal back to its input.
Delay
A Delay is an effect that produces echoes of the input
signal. An additional LFO can modulate the delay times.
Sync On / Off
Synchronizes the Delay to the song tempo of your host
application.
Time 0...2000ms oder 1/64...1t bars
Sets the length of the Delay tap in milliseconds or (if Sync
is activated) in useful musicall values.
Mix 0...100%
This parameter controls the volume ratio between the
original signal and the effect output. If set to 0%, the dry
signal is sent to the outputs only so that no effects can be
heard. Higher values will increase the effect signal. At
maximum setting, the pure effect signal will be heard.
Feedback 0...100%
Controls the amount of signal that is routed back into the
Delay line. Lower values therefore produce fewer echoes
than higher values.
Spread -100...+100%
Spreads the left and right delay output to half of the delay
time maximum. Leftmost and rightmost settings (-50 % or
+50 %) create a typical ping pong delay. While using
settings of ±66% or ±75% will create a triplet or dotted
ping pong delay.
Low Cut 41.18...22050 Hz
Determines the frequency where the lower frequency
parts are divided from the effect signal. A natural delay
doesn´t produce all frequencies equally, so the highpass