Vortech 2003-2006 G35 User Manual

Page 5

P/N: 4NZ020-010

04JUN08 v6.0 Nissan 350Z(4NZv6.0)

Before beginning this installation, please read through this entire instruction booklet and the Street Supercharger System

Owner’s Manual (Race Owner’s Manual for the Renegade kit) which includes the Limited Warranty Program, the Warranty

Registration form and return envelope.
Vortech supercharger systems are performance improving devices. In most cases, increases in torque of

30-40% and horsepower between 45-55% can be expected with the boost levels specified by Vortech Engineering.

This

product is intended for use on healthy, well maintained engines. Installation on a worn-out or damaged engine is

not recommended and may result in failure of the engine as well as the supercharger. Vortech Engineering is not

responsible for engine damage.
Installation on new vehicles will not harm or adversely affect the break-in period so long as factory break-in procedures are

followed.
For best performance and continued durability, please take note of the following key points:

1. Use only premium grade fuel 91 octane or higher (R+M/2).

2. The engine must have stock compression ratio.

3. If the engine has been modified in any way, check with Vortech prior to using this product.

4. Always listen for any sign of detonation (pinging) and discontinue hard use (no boost) until the problem

is resolved.

5. Perform an oil and filter change upon completion of this installation and prior to test driving your vehicle.

Thereafter, always use a high grade SF rated engine oil or a high quality synthetic, and change the oil and filter at

least every 3,000 miles.

Never attempt to extend the oil change interval beyond 3,000 miles, regardless of

oil manufacturer’s claims as potential damage to the supercharger may result.

6. Before beginning installation, replace all spark plugs that are older than 1 year or 10,000 miles with original heat

range plugs as specified by the manufacturer and reset timing to factory specifications (follow the procedures

indicated within the factory repair manual and/or as indicated on the factory underhood emissions tag).

Do not

use platinum spark plugs unless they are original equipment. Change spark plugs every 15,000 miles and

spark plug wires at least every 50,000 miles.

Nissan 350Z/Infinity G35

Installation Instructions

Congratulations on selecting the best performing and best backed

automotive supercharger available today... the VORTECH® supercharger!

TOOL & SUPPLY REQUIREMENTS

• Ø2.5" Hole Saw

• 1/8", 11/64" Drill Bits

• Drill Motor

• Stepless Clamp Crimping Pliers

• Seal Cutter

• Gasket Scraper

• Silicone RTV (Permatex Ultra Grey: 82194 or equivalent)

• Factory Repair Manual (Recommended)

• 3/8" Socket and Drive Set: SAE & Metric

• 1/2" Socket and Drive Set: SAE & Metric

• 3/8" NPT Tap and Handle

• Open End Wrenches: SAE & Metric

• Center Punch

• Springlock 5/16" Fuel Fitting Disconnect Tool

• 5 Quarts SH/CF Rated Quality Engine Oil

• Oil Filter and Wrench

• Flat #2 Screwdriver

• Phillips #2 Screwdriver

• Heavy Grease

• Silicone Sealer

• Drill Motor

• 1/8", 3/16" Drill Bits

• Hex Key Wrench Set

• Wire Strippers and Crimpers

• Utility Knife

If it has been 20,000 miles or more since your vehicle’s last spark plug change,then you will also need:

• Spark plug socket

• NEW spark plugs

GIN

EER

ING

, LL

This manual is related to the following products:

2003-2006 350Z