Vortech 2003-2006 G35 - Manual (Page 27)

P/N: 4NZ020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
04JUN08 v6.0 Nissan 350Z(4NZv6.0)
9
6. SUPERCHARGER MOUNTING PLATE INSTALLATION (2005 and Later
“Rev-Up” Engines), cont’d.
K. Route the oil feed hose outside the driver’s side
frame rail and then to the fitting installed near the oil
filter and tighten. Use the supplied zip-ties to secure.
L. Tighten all of the mounting plate screws.
M. Install the air filter onto the supercharger inlet and
tighten the clamp.
N. Install the idlers in the positions shown. (See Figs.
6-e, 6-f.)
O. Using the 12mm screw set aside in Step 1, install
the aluminum idler with the bearing retaining snap
ring pointed towards the rear of the vehicle. The
screw should pass through: the idler, a pilot spacer,
the 1.1" spacer and the supercharger mounting
plate. Install the supplied nut and washer on the end
of the screw and tighten the idler so that the gilmer
belt is snug. (See Fig. 5-c.)
P. Install the supplied accessory drive belt as shown in
Fig. 6-e. Tighten the belt tensioner until the belt is
tight. Tighten the center nut on the belt tensioner
idler.
Q. Use the supplied sheet-metal screw to secure the
coolant hose support bracket removed in Section 1.
(See Fig. 6-g.)
R. (Non oil fed applications only) Secure the remote
drain hose away from the belt and other hoses using
tie-wraps.
Fig. 6-g
Fig. 6-f
Fig. 6-e / Accessory Drive Belt Routing (300hp Engines)
POWER
STEERING
PULLEY
CRANK
PULLEY
FACTORY IDLER
PULLEY (NOT USED)
SUPPLIED ACCESSORY
DRIVE BELT
SUPPLIED
GROOVED IDLER
SUPPLIED Ø2.5"
SMOOTH IDLER
SUPPLIED Ø2.5"
SMOOTH IDLER
FACTORY BELT
TENSIONER IDLER
SUPERCHARGER
JACKSHAFT
PULLEY
ALTERNATOR
PULLEY