Vortech 2003-2006 G35 - Manual (Page 25)

P/N: 4NZ020-010
©2008 Vortech Engineering, LLC
All Rights Reserved, Intl. Copr. Secured
04JUN08 v6.0 Nissan 350Z(4NZv6.0)
7
5. SUPERCHARGER MOUNTING PLATE INSTALLATION..(2003-2006 Standard
Output Engines Only.) ( For 2005 and Later “Rev-Up” Engines, Skip to
Section 6.), cont’d
M. Install the idlers in the postiions shown in Fig. 5-d.
Make sure that the 50mm screw (longer) is installed
through the top idler.
N. Using the 12mm screw set aside in Step 1, install
the aluminum idler with the bearing retaining snap
ring pointed towards the rear of the vehicle. The
screw should pass through the idler, a pilot spacer,
the 1.1" spacer and the supercharger mounting
plate. Install the supplied nut and washer on the end
of the screw and tighten the idler so that the gilmer
belt is snug. (See Fig. 5-c.)
O. Install the supplied accessory drive belt. Tighten the
belt tensioner until the belt is tight. Tighten the center
nut on the belt tensioner idler. (See the Figs. 5-d,
5-e.)
P. (Applies to non oil fed applications only) Secure the
remote drain hose away from the belt and other
hoses using tie wraps.
Skip Section 6 and proceed with
Sectlon 7.
Fig. 5-e / Accessory Drive Belt Routing
CRANK
PULLEY
POWER
STEERING
PULLEY
SUPPLIED ACCESSORY
DRIVE BELT
FACTORY BELT
TENSIONER IDLER
SUPERCHARGER
JACKSHAFT PULLEY
FACTORY
IDLER
PULLEY
(NOT USED IF
EQUIPPED)
ALTERNATOR
PULLEY
SUPPLIED GROOVED IDLER
SUPPLIED SMOOTH IDLER
Fig. 5-d