Vortech 1997-2001 5.2L/5.9L Durango/Dakota - Manual (Page 23)

P/N: 4CE020-010
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
18AUG00 V 2.1 (Dodge 5.9L Durango/Dak-2)
12. PLENUM AND DISCHARGE INSTALLATION, cont'd.
H. Attach the bypass valve to the discharge
and inlet (see Figure 12-a ).
I. Secure discharge and bypass assem-
blies.
DISCHARGE
TUBE
2-1/2" x 1"
HOSE
VACUUM
HOSE
3-1/2" x 1" HOSE
INLET
DUCT
13
Figure: 12-a
Figure: 12-d
Figure: 12-e
13A. SUPPLEMENTARY FUEL INJECTION COMPUTER (SFIC) AND RELATED
SYSTEM (1997-99 Dakota/Durango only)
A. Using the four supplied #8 x 1/2" screws,
attach the fuel rail mounting tabs to the supple-
mentary fuel rail in the orientation shown. Use
thread locking compound on the bolt threads
for safety.
B. Lightly oil the O-rings on both ends of the
supplied fuel injectors. Install one each of the
supplied injector retainers onto each injector
into the full circle groove on the end of each
injector. Carefully insert the two injectors into
the discharge plenum with the injector connec-
tors pointing down and out (see
Figure 12-a ).
Make sure that the injectors are inserted straight
and are seated firmly into the plenum.
C. Slide the fuel rail onto the installed fuel injec-
tors. Slowly work the rail over the O-rings
being careful not to dislodge or unseat them.
Finish mounting the rail to the plenum using
the two supplied fuel rail spacers and 1/4" x 2-
3/8" bolts. Use a thread locking compound on
the bolt threads for safety. Make sure that the
injectors are seated properly.
Figure: 13A-a