Vortech 1997-2001 5.2L/5.9L Durango/Dakota - Manual (Page 18)

P/N: 4CE020-010
© 2000 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
18AUG00 V 2.1
(Dodge 5.9L Durango/Dak-2)
9A. IGNITION/BOOST CONTROL INSTALLATION, cont'd. (1997-99 Dakota/
Durango only)
H. Refering to Figure 9A-c , drill a #25 hole
through the floor. Remove all paint from
around the hole, ensuring a good electrical
connection. Attach a 12 GA eyelet terminal to
the supplied 2' black 12 GA wire. Secure this
wire to the previously drilled hole on the
vehicle's floor using #12 hardware.
I. Using the supplied hook and loop fastener,
attach the manifold air pressure sensor to the
underside of the center console's front cover.
(See
Figure 9A-d .) Install the front cover
back onto the center console.
J. Following Figure 9A-d , drill a hole in the
center tray where shown with a 3/8" drill and
route the wires from the timing retard control
through this hole. Secure to the inside of the
tray using the provided #12 hardware.
K. Using the included male and female electri-
cal slide connectors, wire all connections
according to the diagram on page 10. Install
the center console and center tray back into
the vehicle and secure with the previously
removed hardware. (See
Figure 9A-e .)
8
Figure: 9A-c
Drill a Hole Through Floor.
Figure: 9A-d
Drill Hole in Center Tray.
Figure: 9A-e
Install Center Console and Tray.